Moderator: MudBug
Jim in Houston wrote:The MagTech 230 gr FMJ is listed as having a diameter of .451 vs .452 for the Hornady 250 gr and 225 gr FTX. I am assuming that the missing .001 is not significant?
Also re the bullet drop chart, while the BM round and the .308 look pretty much the same out to 400 yds, I am wondering what the actual drop is. Since the vertical scale is 1200 inches (100 feet, if my math is correct), I think there is still a difference of 20" or so at 400 yards, which is not visible on the chart.
Now, to go read up on the LG crimp. Unless someone would like to explain it further here?
bigboreshooter wrote:Hey dawg how much would you charge for some of those bad boys, if I sent you the brass and had box of bullets delivered?
Texas Sheepdawg wrote:bigboreshooter wrote:Hey dawg how much would you charge for some of those bad boys, if I sent you the brass and had box of bullets delivered?
Due to liability concerns, and the fact that every rifle has small variations in chambers, I can't load for others. These loads MUST be carefully worked up in the rifle that they will be used in. I'm very sorry. But your safety is most important.
Also, for what it would cost you in the components, brass and ORMD/HazMat shipping costs, you could probably get a good start on a set of dies. I wished there was a short cut but fact is, QuickLoad indicates that these loads have the potential of exceeding SAMMI pressures.
Return to Reloading for the 450b
Users browsing this forum: No registered users and 153 guests