Re: Recoil and What to do about it!
Posted: Tue Mar 09, 2010 7:29 pm
A welcome relief!
Hoot wrote:Thanks;
When my upper arrives, I'll see how it and the A2 stock balance out. That'll drive whether I add additional weight to the back of the it. Interesting solution. It would be interesting to do some experiments with magnetic repulsion. There are neodymium cobalt magnets out there the exert amazing amounts energy for their dimunitive size. They come in many form factors, one being Flat Washer that could allow a guide rod through the center. Depending upon the size, they can exert up to ~50 pounds of repulsion in pairs. Just an idea...
Hoot
Hoot wrote:For the chamber, I was thinking of a piece of threaded and capped black-pipe of sufficient ID to accommodate either aftermarket recoil reducers or dead weight.
Hoot
2zero6 wrote:Hoot wrote:For the chamber, I was thinking of a piece of threaded and capped black-pipe of sufficient ID to accommodate either aftermarket recoil reducers or dead weight.
Hoot
What about a wax mold instead of the pipe? Then just use low heat to melt the wax and pour off.
gunnut wrote: Maybe I should post some better pictures. I've already done that for you. The A2 Recoil-less butt stock is poured with high impact resins and has 2 cavities 15/16 Dia. x 4.5" deep.